Walk-in Repairs

REPAIR OF EXISTING WALK INS:

Before and after photos

The above photos are an example of an older walk in cooler that had to be updated to health codes.

Do to the original way the walk-in was constructed it is a load bearing structure to the building.

The walk-in was not remove due to load bearing conditions.

Update to health codes with maintaining integrity to the building.

Short down time for the customer.

WHAT WAS DONE:

	Interior of floor was reinforced and claded with #304 - #2 finish stainless steel.
	Interior walls and ceiling were stripped of old glass board and our Aagaard Sectional Cooler mini sectional system was installed with #304 - #2 finish stainless steel.
	Exterior done in stucco alum. white finish
	#304 - #4 finish stainless steel corner trim.
	Walk through door removed and replaced with our flush mount door with door section.
	Chef doors removed and replaced with two glass doors with frame.

Revised:2010

Note: This web sight is maintained by Aagaard Sectional Cooler.

Any problems with this web sight contact us.